19
low the following steps:
- Empty completely the beans hopper
(2).
- Press the grinding switch in order to
get rid completely of the remaining
coffee beans.
- Pour a pack of grinder detergent
powder (PL104) into the hopper (2),
paying attention to the fact that the
powder must penetrate the mills.
- Press the switch (4) for about 5 se-
conds so that the powder penetrates
completely through the mills.
- Fill the hopper (2) with coffee beans.
- Throw away the rst couple of por-
tions of ground coffee.
- The cleaning is over.
Maintenance
We advise to replace the mills periodi-
cally, once worn out.
Maintenance has to be fullled just by
an authorized service center and with
original spare parts.
To Next Page
Loading...
