Lelit William - PL72 - Adjust the Doses; Reset the Parameters; Energy Saving

Lelit Espresso - English
EN
13
Note. If the coee ow in your espresso machine is very slow, the coee grinding is
too ne, if it’s quick, the coee grinding is too coarse. Many factors inuence the coee ow
such as: the amount of coee, its pressing, the espresso machine adjustments, how clean the
lters are and also the climatic conditions.
H
Adjust the doses
Note. e grinder is tted with the LCC (Lelit control center), which allows to
program the grinding time for both doses.
Note. e factory pre-set parameters are 3,0 seconds for 1 dose and 5,5 seconds for
2 doses. e grinding time can vary from 2 seconds to 20 seconds.
H.1 To enter in the programming mode and change the grinding time for 1 dose,
press once the “-” button, the display shows the icon and the time (3,0”) for 1 dose.
H.2 To enter in the programming mode and change the grinding time for 2 doses,
press twice the “-” button, the display shows the icon and the time (5,5”) for 2 doses.
H.3 Press the “+” button to access, and then press the “-” or “+” button to de-
crease or increase the grinding time.
H.4 Three seconds after the last press of a button, LCC stores the data and exits
from settings mode.
I
Reset the parameters
I.1 To reset the electronic card, turn the grinder off. Once off, keep the “+” button
of the LCC pressed, and then turn on the grinder by pressing the switch (5), the
“Preset done” message will appear on the LCC display to conrm that the reset
has been completed. Turn off and turn on the grinder by pressing the switch (5).
J
Energy saving
J.1 When the grinder has not been used for 30 minutes, it goes in stand-by, the
LCC display turns off and the led light (6) blinks every 3 seconds.
J2. To turn it back on, press the button (7) (PUSH) or the button (4) (adding coffee).
Note. To disable the stand-by function, turn the grinder o, by pressing the switch (5).
Keep the button (4) (adding coee) pressed and turn the grinder back on by pressing the
switch (5), the led light (6) will remain o. Turn o and turn on the grinder by pressing the
switch (5).
Note. Every time the grinder is turned on, if the stand by function is disabled, the led