- Check the gearbox for oil leakage (for oil change - see “7.5
Change of oil in gearbox”).
- Check the bolts of the bearing plate for tightness (fig. 18).
Tighten these bolts with a torque of 330 Nm (33 kgm).
- Check all bolts and nuts for tightness. Pay particular
attention to the bolts which secure the skids and wear
plates (fig. 19).
When tightening loose bolts/nuts the torques listed below
should be applied.
37
M6 M8 M10 M12 M14 M16 M20 M24
Nm 10 25 50 85 135 215 410 710
kgm 1,0 2,5 5,0 8,5 13,5 21,5 41,0 71,0
18
330 Nm (33 kgm)
19
To Next Page
Loading...
