Need help?Do you have a question about the LELY Splendimo 320 MC and is the answer not in the manual?
General| Brand | LELY |
|---|---|
| Model | Splendimo 320 MC |
| Category | Lawn Mower |
| Language | English |
Introduction to the operator's manual and safety guidelines.
Details regarding the warranty period and terms for replacement parts.
Locating and recording the machine's unique type and serial numbers.
Essential safety rules and precautions for operating the machine safely.
Interpretation of various safety symbols and warnings present on the machine.
Description of the LELY SPLENDIMO MC mower conditioner and its components.
Connecting the mower to the tractor's three-point hitch and adjusting linkage pins.
Connecting hydraulic hoses for mechanical and hydraulic ground pressure relief systems.
Steps to move the mower into its transport position and safety checks.
Adjusting the forward inclination of the cutter bar to set the mowing height.
Adjusting the crop inlet plate and rotor for desired conditioning intensity.
Setting mechanical or hydraulic ground pressure relief for optimal ground contour following.
Adjusting the speed at which the machine descends for headland operations.
Adjusting the swath board to control the width of the laid swath.
Ensuring safety covers are fitted and nobody is near the machine before engaging PTO.
Steps for lowering the machine, engaging PTO, and maintaining working speed.
Procedure for safely dismounting with mechanical ground pressure relief.
Procedure for safely dismounting with hydraulic ground pressure relief.
Cleaning, checking, and greasing the machine after use.
Greasing points and intervals for PTO shaft, bearing blocks, and pivot points.
Maintenance tasks performed at the start of the season, before storage, or during extensive use.
Procedure for replacing worn or damaged mower knives, ensuring disc balance.
Schedule and procedure for changing oil in gearboxes and the drive element.
Replacing grease in mower elements at specified intervals for optimal performance.
Procedure for dismantling and reassembling the cutter bar unit.
Steps for replacing a mower disc on the cutter bar's drive element.
Adjusting the clearance between the top hood and the conditioner rotor.
Adjusting the position of the conditioning rotor relative to the cutter bar.
Changing the conditioner rotor speed by replacing the drive pulley.
Diagram of the hydraulic ground pressure relief system and its components.
Procedure for adjusting the minimum system pressure for ground pressure relief.
Common issues and solutions for the hydraulic ground pressure relief system.
Skids fitted under the cutter bar to improve ground contour following.
Wear plates to protect skids from abrasion.
Topping skids allow mowing higher above field level in rough conditions.
Caps to improve crop flow and swath formation.
Alternative pulley to adjust conditioner rotor speed for varying crop conditions.
Fins to disperse crop across the cutter bar's full width.
Pushes un-mown crop to the side to prevent build-up in long crops.
Extensions to reduce swath width, avoiding tractor wheel damage.
To Next Page
