Do you have a question about the Lem Elettronica DSP35SAT-5G and is the answer not in the manual?
Configure FM and BI input settings, including frequency range and channel filtering.
Adjust FM/BI input attenuation levels for optimal signal strength.
Set up the satellite input, including frequency range and gain.
Enable or disable LNB remote power supply (13V/18V) for satellite inputs.
Adjust the attenuation level for the satellite input signal.
Configure the slope adjustment for the satellite signal.
Configure remote power supply (12V/24V) for the VHF input.
Enable or disable the preamplifier for the VHF input.
Apply filtering to a single MUX, specifying channel and level.
Activate the 65MHz DAB filter for the VHF-DAB signal.
Configure filtering and conversion for a single MUX, setting input/output channels.
Add filters for two adjacent MUX channels, specifying levels.
Configure overlapping output filters with the same frequency.
Remove a previously applied filter or MUX conversion.
Select DC voltage setting (12V or 24V) in advanced menu.
Set a passcode to protect device settings from unauthorized access.
Select non-standard filter bandwidth for specific applications.
Adjust the minimum threshold for auto-tuning and monitoring.
| Category | Computer Hardware |
|---|---|
| Manufacturer | Lem Elettronica |
| Model | DSP35SAT-5G |
| Output Power | 35W |
| Output Voltage | 5V |
| Efficiency | 85% |
| Protection Features | Overload, Overvoltage, Short Circuit |
Loading...