fx 12
7
warm sound.
4. Bright Room
Simulate a reverb of a small room characterized with a
bright sound.
5. Warm Vocal
Typical reverb for voices characterized with a warm
sound.
6. Bright Vocal
Typical reverb for voices characterized with a bright
sound.
7. Plate Reverb
Typical '70 reverb sound.
8. Stereo Delay
Echo effect with ping-pong of left and right channels.
9. Mono Delay
Normal echo effect.
10. Chorus
Typical chorus effect, that can be used with voices and
instruments.
11. Flanger
Typical fl anger effect, that can be used with voices and
instruments.
12. Vibrato
Typical vibrato effect, generally used with instruments.
13-16. Rev + delay / chorus / fl anger / vibrato
Various combined effects.
Unbalanced JACK connector that sends the left channel
signal if used in conjuction with the right output or the
sum of both channels if used alone. It can be used with
all equipment capable of high level signal input.
11. FOOTSWITCH
Allows to connect a footswitch to turn on/off the Digital
Effect Processor; let know that only the effected sound
(WET) is left out, the natural sound (DRY) pass through
the device unaltered.
6. Connections (fi g. 3 and 4)
The fx 12 can be connected to a mixer or an
instrument amplifi er with input and output capable of
LINE level signals.
1. MIXER CONNECTION
This kind of connection is the most commonly used to
have the effect both for voices and instruments.
Rotate the MIX control fully clockwise on WET position
and set at center the INPUT and OUTPUT controls,
afterwards you will make a fi ne regulation.
Set up the voices or instruments without the WET
sound directly from the channel fader.
Set up the quantity of WET sound for each voice or
instrument with the AUX control of the same channel.
Set up the WET sound for the whole mix by the AUX
input on the mixer.
2. INSTRUMENT AMPLIFIER CONNECTION
This kind of connection is the most commonly used in
conjuction with instrument amplifi es such as guitars or
keyboards and so on.
Rotate the MIX control at center between WET
and DRY positions and set at center the INPUT and
OUTPUT controls, afterwards you will make a fine
regulation.
The footswitch will enable or disable the effect.
7. Preset
Follows a brief description of each preset, the
PRESET LIST will provide a more detailed list of their
variations.
1. Warm Hall
Simulate a reverb of a big hall characterized with a
warm sound.
2. Bright Hall
Simulate a reverb of a big hall characterized with a
bright sound.
3. Warm Room
Simulate a reverb of a small room characterized with a
To Next Page
Loading...