LEM Mighty Bite 8 - Troubleshooting and Maintenance; Troubleshooting Common Issues; Grinder Features and Parts; Cleaning and Maintenance Procedure

CAUTION
Before cleaning, assembling or disassembling meat grinder, make sure the grinder motor
is OFF and the plug is removed from the outlet/power source.
GRINDER FEATURES
CLEANING AND MAINTENANCE
LEM Products • West Chester, OH 45011 • PH: 1-877-536-7763 • www.lemproducts.com
LEM Products • West Chester, OH 45011 • PH: 1-877-536-7763 • www.lemproducts.com
6
3
If your unit fails to operate, contact LEM Products technical assistance Toll Free at 1-877-536-
7763. If meat is mashing instead of extruding in strings from the grinding plate, chill the meat
to 40˚, and check to see that the plate and knife are properly installed. A dull knife or plate will
also cause mashing of the meat. For an overheated plug or grinder housing discontinue use
and contact technical assistance Toll Free at 1-877-536-7763
This product is equipped with a polarized AC (Alternating Current) plug (a plug having one
blade wider than the other). This plug will t into the power outlet only one way. (If the plug
does not t fully into the outlet, reverse the plug. If it still does not t, contact a qualied
electrician. Do not modify the plug.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY.
Always be as thorough as possible when cleaning and sanitizing components. Any parts
exposed to raw meat may harbor or develop bacteria possibly causing illness or death.
CAUTION
Cuts, injuries and/or re may result from non-compliance with all operating procedures
described within this instruction manual.
TROUBLESHOOTING
5
17
10
11
1
2
3
4
12
6
7
8
9
18
13
14
16
15
Part #
10
11
12
13
14
15
16
17
18
QTY
1
1
1
1
1
1
1
1
1
Description
AUGER WASHER
AUGER BUSHING
HEAD
STOMPER
MEAT PAN
STAR BOLT
HOUSING
POWER SWITCH
HEAD ATTACHMENT HUB
Part #
1
2
3
4
5
6
7
8
9
QTY
1
1
1
1
1
1
1
1
1
Description
RETAINING RING
1/2” STUFFING TUBE
1” STUFFING TUBE
1 3/8” STUFFING TUBE
10 mm PLATE
4.5 mm PLATE
STUFFING PLATE
KNIFE
AUGER
WARNING!
HOW TO CLEAN YOUR GRINDER:
Meat remaining in the Grinder Head may be moved through by passing a slice of bread through
the Grinder Head.
1. Before clean up of the grinder, switch the appliance o and unplug from electrical socket.
2. Remove the Meat Stomper (#13) and Meat Pan (#14).
3. Unscrew Star Bolt (#15) and remove the Grinder Head by pulling straight out.
4. Unscrew the Retaining Ring (#1) and remove all parts from the Grinder Head.
Hand wash in warm soapy water. Grinder parts are NOT DISHWASHER SAFE.
CLEAN IMMEDIATELY AFTER USE.
5. Rinse with clear hot water and hand-dry IMMEDIATELY. DO NOT soak.
NOT DISHWASHER SAFE (discoloration may occur).
6. We advise you to lubricate the Knife and the Grinding Plates with silicon spray
(available at LEM Products.)