EasyManua.ls Logo

LENCO DAB-11 - Page 10

LENCO DAB-11
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Using the alarm
Alarm Setting
With radio on, press and hold the Info/Menu button.
Then press the Prev or Next button to choose Alarm 1 to ON position, press Enter/Snooze button to
confirm.
The hours will flash, use the Prev or Next button to select hour. Press Enter/Snooze button to confirm.
The mins will flash, use the Prev or Next button to select the minutes. Press Enter/Snooze button to
confirm.
The Vol digit will flash, use the Prev or Next button select the Volume. Press Enter/Snooze button to
confirm.
The Mode: Alarm will flash, use the Prev or Next button select the Alarm source: Alarm/DAB/FM. Press
Enter/Snooze button to confirm.
With radio on, press and hold the Info/Menu button.
Then press the Prev or Next button to choose Alarm 2 to ON position, press Enter/Snooze button to
confirm.
The setting procedures is the same as the “ALARM1”.
NOTE: You can press the Info/Menu button to get back last one step when in the process of the setting
the alarm.
Deactivate the alarm
Press and hold the Info/Menu button, then select the alarm you wish to turn off using the Prev or Next
button to choose the Alarm to OFF position.
Press Enter/Snooze button.The alarm will be deactivated.
Turning off the alarm
Press the Power/Standby button to turn off the alarm when the alarm is sounding.
NOTE: The alarm will keep ringing for 1 hour if you do not turn it off when it is sounding.
Snooze Function
When the alarm is sounding, press the Enter/Snooze button to turn off the alarm temporarily. The
alarm will be delayed for 9 mins and then come on again.
Station information on DAB mode
Every time you press the Info/Menu button in the DAB mode, the display will cycle through the
following display modes:
Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
Signal Strength: Displays a signal bar with the current station strength.
Bit Error Rate (BER): Provides details of the signal error rate.
Channel Frequency: Displays the station’s transmission channel number and frequency.

Related product manuals