There are 3 independent Alarms which can be set. 2 different Alarms (Alarm 1,
Alarm 2) and one NAP alarm which is a countdown alarm can be used when
doing a quick sleep.
Press the Alarm button on the remote control to enter the alarm settings
menu directly and follow the following steps.
Setting the alarm
- Press ‘Alarm’ button on the unit or remote.
- Select Alarm 1
- Select Turn On
- Press the ‘OK’ button on the remote or press the navigation wheel on the
unit.
- Press the ‘OK’ on the “Repeat:” option and select the how the alarm
should work.
(Everyday, once or select the required days)
- Press the left arrow key on the remote or unit to return to the previous
alarm menu.
then select “Time:” and press “OK”.
- You now can use the up down buttons to change the highlighted Hours
then press the right arrow button once to switch to the Minutes and use
the up/down buttons to change the minutes. Press the “OK” button to
confirm.
- Select the “Sound:” and press the “OK” button. Now you can choose
from Beep, Melody, Internet radio, FM, DAB/DAB+.
When internet radio is selected as wake up sound, you can use one of
your favorite radio stations (which have to be stored as favorite on the
DIR-141).
Note: when no internet connection is available within 1 minute after
the alarm is activated, the DIR-141 will automatically switch to Melody.
Repeat the above steps to setup the alarm 2.
Setting the NAP alarm
- Press ‘Alarm’ button on the unit or remote.
- Select NAP alarm.
- Use the up/down buttons to choose the desired minutes.
You can choose 5/10/20/30/60/90 or 120 minutes and then press the
“OK” button to select.
- Press the left arrow button to return to the main screen.
When the NAP alarm is activated you see a clock icon on the lower right corner
with the remaining time.
To Next Page
Loading...
