Setting up your turntable
Please carefully remove the product from the packing case and unpack all packing materials.
Check that all accessories are complete. Then choose a flat and safe place to assemble the
turntable.
Installing the metal platter and turntable mat
Note: The belt is preinstalled on the bottom of the metal platter
1. Make sure that the belt is not twisted, then use your thumb to stretch the belt until it
reaches the round hold in platter.
Note: Make sure that you place the belt on the metal track and not on the section with
teeth.
2. Still holding the belt, flip the platter over, then insert the platter onto the spindle in the
center of your turntable.
3. Align the round hole in the platter with the pulley and use your finger to hook the belt
onto the pulley.
4. Place the turntable mat on the platter.
Note: When you want to take out the platter from the turnble, remover the mat first, then
grasp the platter and pull it upward. This is especially important if you are shipping your
turntable to prevent the platter from shaking.
Installing the dust cover
1. Insert the dust cover hinges into the hinge bases on the back panel of the unit.
To Next Page
Loading...
