2. Hold the dust cover and insert it into the hinges.
Power the turntable
You can power the device with the supplied AC/DC adaptor. Check the rating plate on the
AC/DC adapter with your mains power voltage before powering the device on. The AC/DC
adapter is 100-240V~50/60Hz input, 12V 0.6A output.
Note:
· To disconnect the device from the mains, pull out the mains plug out of the wall outlet.
· If there is no operation for 15 minutes after the end of the play, the machine will
automatically shut down. To use it again, set the Power/RPM selector switch to the OFF
position and then select 33/45 RPM again.
Remove the stylus cover
Please remover the stylus cover before playing the record.
Using your turntable
Playing a record
1. Gently open the top cover.
Note: Be careful not to pinch your finger when opening or closing the top cover.
2. Place a vinyl record on the turntable.
To Next Page
Loading...
