3. Select the appropriate speed by turning the RPM selector switch to 33 or 45. And at the
same time, you must select the appropriate size by slid the SIZE selector switch to 7’ or 12’.
4. Remove the clip on the tone arm holder to release the tone arm.
5. Press START button, the tone arm will automatically move to the record and start
playing the record.
6. Press the Fast forward/Fast Backward button to jump the track. Long press will
continuously jump the track.
7. Press UP/DOWN button, the tone arm will be raised or lowered. The playback will play
or pause.
8. After the record is finished playing, the record stops rotating, and the tone arm will
automatically returns to the tone arm seat.
NOTE: When not in use, please fasten the arm lock to prevent the arm from loosening and
damaging the stylus or turntable.
Listening to music using Bluetooth speakers
1. Turn the switch to your record type, 33 or 45. And select the size of record, 7’ or 12’
2. Put your Bluetooth speaker in pairing mode.
NOTE: Make sure that Bluetooth is off on any devices in the vicinity that will automatically
connect to your speaker.
3. On the turntable, press the Bluetooth button enter to pairing, the Bluetooth indicator
will flash blue.
4. When connected successfully, the Bluetooth indicator lights solid.
5. Long press the Bluetooth button can disconnect the currently connected Bluetooth
speaker.
Note: If pairing fails, the Bluetooth indicator will light red. You can press the Bluetooth
button to restart the pairing or long press the Bluetooth button to exit the Bluetooth
transmission.
Listening to through the RCA jacks
1. Plug the red and white connectors on the included RCA cable into the RCA jack on the
back of your turntable, red to red and white to white.
2. Plug the other end of the cable into your speakers, red to right speaker and white to left
speaker.
3. Toggle the PRE-AMP ON/OFF switch to selector the output mode.
Replacing the stylus (Part number: Audio-Technica ATN3600L)
The stylus should last about 300 hours under normal use. However, we recommend that you
replace the stylus as soon as you notice a change in sound quality. Prolonged use of a
worn-out stylus can damage records.
1 Turn the RPM selector switch to OFF to turn off the power.
2 Remove the stylus by pulling it downward and forward at the same time.
To Next Page
Loading...
