LENCO MC-013 - Page 8

8
TUNE TO A FM STATION PRESET
In FM mode:
Press P+ P- button to move to the preset location and station that you would like to listen to (1-30). When
you pause between each press the frequency stored under each preset location will be displayed and
the Micro will tune to and play the stored station�
COMPACT DISC PLAYBACK
CD mode
Check that your Micro is in CD mode. If you are not already in CD mode, briey press and release the
‘Mode’ button until you are in CD mode (check the display)�
Play a CD
1� Press and release the lid of the CD player on the front right edge� ‘OP’ will be displayed�
2� Place an audio CD, label side up, into the CD compartment� Please ensure that you line up the hole
in the center of the CD, with the central spindle and press down into place�
3� Close the lid of the CD player, pressing down on the front right edge, ensuring that it ‘clicks’ shut� ‘_ _ _’
will be displayed and after a short delay the number of tracks on the CD will be displayed� And it will
play automatically of the 1st track�
Note: If there is no CD in the compartment, ‘no’ will be displayed�
CD controls
You can use the following controls on your Micro in CD mode�
• Play
Press button on the Micro. The track will begin to play and the ‘PLAY’ icon will be displayed.
• Pause
Press button. The ‘PLAY’ icon and the elapsed time of the track will ash.
Press button again to continue to play the track
• Next track:
Press
Tune
button�
• Previous track:
Press
Tune
button�
• Fast forward within a track:
Press and hold the
Tune
button�
• Fast backward within a track:
Press and hold the
Tune
button�
• Stop
Press and release the / button�