EasyManua.ls Logo

LENCO PMX-300 - Page 9

LENCO PMX-300
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
OPERATING
NORMAL FUNCTION
1. Select power switch on the backside of the speaker to AC or DC mode.
2. Select an audio source by pressing the INPUT A key on the front panel to display AUX A, BT A, FM, USB A.
Press the INPUT B key on the front panel to display LINE, USB B.
When unit is AC mode:
- Pressing standby buon once will acvate charging mode, showing the baery charging status on
the blue led-display.
- Pressing standby buon second me will acvate the speaker and showing green charging light.
- You can also select the standby mode, without charging the baery
When unit is DC mode:
- Pressing standby buon shows the baery level on the blue led display
3. Rotate the VOLUME/MULTI/DJ EFFECT wheel on the control panel or the VOL+/- key on the remote
control to adjust the main volume. Then adjust the volume slider of INPUT A and use the right volume
slider to change the volume of INPUT B.
4. To
adjust the bass, treble, X-drive, speaker lights and main volume, press the menu key to select bass,
treble, X-drive, speaker lights, and then rotate the big VOLUME/MULTI/DJ EFFECT wheel.
5. PHONES OUTPUT selecon. Press the PHONES MODE buon on the control panel to display INPUT A,
INPUT B, or INPUT AB and adjust the volume of A,B or AB by rotang the mul DJ eect wheel.
6. Press the LIGHT buon on the remote control or press th
e MENU buon on the front panel unl
speaker light mode is displayed, then rotate the VOLUME/MULTI/DJ EFFECT wheel to select to OFF, R,
G, B, RG, RB, GB, RGB, AUTO, DEMO light mode.
7. Press the MUTE key on the remote to mute, press it again to reset.
8. Press X DRIVE on the remote to turn on/o X-Bass eect.
SPEAKER LIGHT COLOR CONTROL OPTIONS
R = red lights ash
G = green lights ash
B = blue lights ash
RG = red and green lights ash RB = red and blu
e lights ash GB = green and blue lights ash
RGB = red, green, and blue lights ash
Auto = the various color combinaons cycle through and ash.
Demo = lights ash and change color as if they were responding to the beat of the music.