LENCO SCD-680 - Playback via USB Storage Media; Connecting and Playing USB MP3 s; Listening to Tape; General Tape Operation

Version: 1.0
 Press“Stop ”buttontwice(10)atCDstopmodetocancelallprogrammedmemoryuntilthe“Prog”indicatordisappear
onLCDdisplay(8).
 ForMP3disc/file,pressthe“Folderup”button(20)toselectthe1
st
trackofnextfolderdirectlyandhencetospeedupthe
songselection.

 Theprogrammingmodewillautomatically stopifnobuttonisbeingpressedinaperiodofabout30secondsafterpressing
theMemorybutton(12).
Remark:‐
MP3trackformatrequirement:‐
- Bitrate:32kbps~320kbps,samplingrate:32kHz,44.1kHzand48kHzdecodable
- TheperformanceofplayingMP3discisvariousfromthequalityofrecordingdiscandthemethodofrecording.Furthermore,
thesearchinglead‐timeforMP3‐CDislongerthannormalCDduetodifferenceformat.

PlaybackofMP3songviaUSBstoragemedia
Connecting
ThesystemisabletodecodeandplaybackallMP3filewhichstoredinthememorymediawithUSBconnectingport.

1. SetthesystematStandbymodefirstorotherfunctionex ceptUSBmode.
2. Plug‐intheUSBpen‐drivewiththefaceup&makesureitgoing
intocompletely.
 ConnectingtheUSBupsidedownorbackwardscoulddamagetheaudiosystemorthestoragemedia(USBthumbdriver).
Checktobesurethedirectioniscorrectbeforeconnection.
3. TurnontheunitagainbyOn/offbutton(17)andsetpressFunctionbutton(9)toselect
USBmode.Thesystemwillstart
readingthestoragemediaautomaticallyafterconnecting,andLCDdisplay(8)willshowthetotalnumberofMP3filesbeing
detected.
4. RepeatthesameplaybackprocedureasplayingCD/MP3discasabove.

Remark
- ThesystemcandetectandreadthefileunderMP3formatonlyatUSBmodebutnotothermusicfileformat.
- IfconnectthesystemtoMP3playerviatheUSBsocket,duetovariancesinfilesystemformat,someMP3playermaynot
beabletoplayviathe
USBsocket.Thisisnotamalfunctionofthesystem.
- USBportdoesnotsupportconnectionwithUSBextensioncableandisnotdesignedforcommunicationwithcomputer
directly
- DuetoErPstagetworequirementandprotecttheenvironment(forEuropeanmarketonly).Theunitwillswitchto
standby
modeautomaticallyoncenoanymusicplayingover15minutes.

RemovingofUSB
ToremovetheUSBturnoffthepowerorswitchthefunctionmodetoeithercd ortunermodefirst.ForUSBport–un‐plugitby
pullingouttheUSBsocketdirectly

Listeningtotape
Generaloperation
Stop/ejectkey presstostopalldeckoperation.Pressagaintoopenthecassettedoor.

Fast forward key &
Fastrewindkey
press to start rapid tape winding in either forward or reverse direction. Press stop/eject key, the
cassettespoolsstopturning.

Playkey presstostartplayingtape.

Pause
key presstostoptapeoperationtemporarily.Pressagaintoresumeplay.

Playback
 Select“Tape”byFunctionbutton(9)
 Putinthecassettetape.
 Pressplaykey toactiveplayback
 AdjusttheVolumeup/downcontrol(14)tothedesiredlevel.
 Usepausekeywhenyouwanttostopplaybacktemporarily.
 Pressstop/ejectkeywhenfinished.

Morefeatures
A. Alarmclocksetting
This function allows the system to turn on automatically and wake you up CD, FM/DAB, Tape or USB mode. Set the system at
standbymode,thenpressandholdthe“Timer”keytoentertheTimersettingmode,LCDwillshowTimerOntime,Moreover,the
timerclockwillflashthe
hourdigit,meanstheunitalreadyentertimersettingmode.