D
Debra HuntSep 8, 2025
What to do if the wall outlet for my Lennox Hearth Products Winslow (PS40) is not energized?
- SShannon FisherSep 9, 2025
If the wall outlet is not energized, check the circuit breaker panel.
To Next PageTo Next PageWhat to do if the wall outlet for my Lennox Hearth Products Winslow (PS40) is not energized?
If the wall outlet is not energized, check the circuit breaker panel.
What to do if the power cord of my Lennox Hearth Products Winslow (PS40) Stove is not plugged in?
If the power cord isn't plugged in, the solution is simple: plug it in.
What should I do if the Burn-Pot of my Lennox Hearth Products Stove is dirty?
If the Burn-Pot is dirty, clean it.
What to do if Burn-Pot of my Lennox Hearth Products Winslow (PS40) is dirty?
If the Burn-Pot is dirty, clean it.
What to do if the hopper of my Lennox Hearth Products Winslow (PS40) is empty?
If the hopper is empty, fill it.
What to do if the igniter fuse of my Lennox Hearth Products Winslow (PS40) is blown?
If the igniter fuse is blown, replace the 6 amp fuse located on the front of the control board.
What to do if the board of my Lennox Hearth Products Winslow (PS40) is broken, damaged, or defective?
If the board is broken, damaged, or defective, replace the control board.
What to do if the vacuum hose of my Lennox Hearth Products Winslow (PS40) Stove is plugged?
If the vacuum hose is plugged, clean or replace it.
What to do if the auger tube of my Lennox Hearth Products Winslow (PS40) Stove was not full of pellets when start button was pushed?
If the auger tube was not full of pellets when the start button was pushed, when cool, empty pellets in Burn-Pot and push start button again.
What to do if the front door of my Lennox Hearth Products Winslow (PS40) Stove is not sealing?
If the front door is not sealing, latch or adjust the front door, or replace the door gasket.
General| Brand | Lennox Hearth Products |
|---|---|
| Model | Winslow (PS40) |
| Category | Stove |
| Language | English |
Essential rules for safe installation and operation of the pellet stove.
Critical alerts regarding potential hazards and improper use.
Required minimum distances from the stove to flammable materials.
Mandatory conditions for safe exhaust vent termination.
Guidelines and requirements for connecting the stove's vent pipe.
Procedure for starting the pellet stove ignition sequence.
