11
UNIT INSTALLED ON SHOCK ABSORBERS
MOUNTING PLATES
MODEL 24E
MODELS 32E-38E-43E
MODELS 48D/D2-64D/D2-76D/D2-86D/D2
Clearance around the unit for service and maintenance
SERVICE SPACE
Space should be left free for access or servicing, to ease the installation, as well as easy access to the unit.
2.- INSTALLATION
- The unit is able to work in normal radioelectronic conditions for
commercial and residential installations. For any other conditions
please consult.
- The bedplate is made up of metal channels, capable of with
standing the weight of the units.
- If the unit is floor mounted, then the profiles should be isolated
with shock absorbing material such as anti-vibration or pads.
Keep in mind that fans rotate at approximately 850 rpm.
Sizes in mm
- If the outside temperature in the area where the heat pump unit
is to be installed is low or the cycle functioning are too long, it may necessary to install an electrical heater, below
the likely coils on the drip tray, which avoids the causing of ice in the coil during defrost cycle.
Floor supports
(shock absorbers)
o
/
14
130
25
1145
1195
400
660
o
/
14
90
25
1145
1195
800
980
o
/
14
197,5
25
955
1960
800
1195
955
2.4.- INSTALLATION CLEARANCES
2.3.- UNIT LOCATION
1 m.
1 m.
1 m.
1 m.
To Next Page
Loading...
