To Next PageTo Next PageWhat to do if my Lennox EDV3530CNM-B burner will not light?
If your Lennox Indoor Fireplace burner will not light, there may be a faulty valve system or a defective 'OFF/ON' wall switch. Disconnect the two black wires from the wire nuts and check for continuity with a multimeter.
Why does my Lennox EDV3530CNM-B Indoor Fireplace pilot keep going out?
Frequent pilot/burner outages in your Lennox Indoor Fireplace may occur if the pilot valve flame is too low or too high, causing the pilot safety to drop out. Clean and/or adjust the pilot flame for maximum flame impingement on the thermocouple.
What to do if my Lennox EDV3530CNM-B Indoor Fireplace burners come 'ON' but go 'OFF'?
If the burners on your Lennox Indoor Fireplace turn on but then turn off, check the main burner orifice(s) for any blockage. Clean or replace the orifice if necessary. Also, check the vent system for obstructions.
What to do if pilot burning, but no gas to burner in Lennox Indoor Fireplace?
If the pilot light is burning but no gas is going to the burner in your Lennox Indoor Fireplace, even with the valve knob and wall switch 'ON', check the wall switch and wires for proper connections. Also, the thermopile may not be generating sufficient millivoltage, so check the thermopile terminals with a millivolt meter. Finally, check the burner orifice for any blockage and remove it.
How to fix Lennox Indoor Fireplace pilot that won't stay lit?
If the pilot light on your Lennox Indoor Fireplace will not stay lit after following the lighting instructions, the pilot generator thermocouple may be defective. Check the pilot flame impingement on the thermocouple. Clean and/or adjust the pilot for maximum flame impingement on the thermocouple.
How to troubleshoot Lennox EDV3530CNM-B spark ignitor that won't light pilot?
If the spark ignitor on your Lennox Indoor Fireplace will not light the pilot after repeated attempts, check for a spark at the electrode and pilot. If there is no spark and it is properly connected, replace the ignitor. You can also use a match to trigger the ignitor mixture cause recommended and pilot. Check the inlet gas pressure to ensure it is within the limits marked on the rating plate. Finally, clean or replace the pilot orifice if it is plugged.
General| Brand | Lennox |
|---|---|
| Model | EDV3530CNM-B |
| Category | Indoor Fireplace |
| Language | English |
Crucial safety warnings for operation and potential hazards.
Steps to take if a gas leak is detected.
Alerts about high surface temperatures and burn risks.
Importance of proper installation and risks of modification.
Hazards related to gas, hot surfaces, and proper installation.
Information on CO poisoning signs and precautions.
Warnings and recommendations for supervising children around the appliance.
Essential safety warnings regarding log installation, materials, and potential hazards.
Understanding proper flame appearance and identifying sooting problems.
Instructions and guidelines for adjusting the air shutter for optimal flame.
Safety warnings and detailed steps for adjusting burner flame appearance.
Essential safety warnings and gas leak procedures before lighting the millivolt valve.
Detailed instructions for lighting the millivolt gas valve pilot and burner.
Procedures for safely turning off the gas supply to the appliance.
Essential safety warnings and gas leak procedures for electronic models.
Detailed instructions for lighting electronic ignition systems.
Guide to diagnosing and resolving common problems with the millivolt gas control system.
Guide to diagnosing and resolving common problems with electronic ignition systems.
