Lennox EL296UHV - Page 42

Page 42
Optional Accessories for use with any icomfort Touch
®
System
FIGURE 58
NOTE: 24V UV LIGHT
APPLICATIONS
In an icomfort by Lennox system,
neither furnace nor air handler
transformer will have adequate VA
to power 24V UV light applications.
An additional transformer for UV
light applications is required.
Icomfort Wi-Fi
®
THERMOSTAT
Discharge Air Sen
sor (Required for
even heat)
NOTE: Icomfort Wi-Fi
®
THERMOSTAT SENSES HUMIDITY &
CONTROLS HUM CONTACTS TO CYCLE HUMIDIFIER BASED
ON DEMAND. NO OTHER CONTROL OR HUMIDISTAT RE
QUIRED.
OPTIONAL OUTDOOR AIR SENSOR FOR USE WITH HUMIDI
FIER (IF NOT ALREADY IN THE SYSTEM FOR OTHER FUNC
TIONS. BUILT INTO ALL icomfort by Lennox OUTDOOR UNITS).
Maximum total
length of all connec
tions on the RSBus
is limited to 1500ft.
Wire gauge of
RSBus wire is 18.
RSBus
Rf WGhGsCf
HVAC EQUIP
DEHUMIDIFIER
CONTROL
HVAC
EQUIPMENT
DH
STANDARD 1 OR 2 STAGE
AC OR HP UNIT
*24V IN
JUMPER
icomfort
®
ENABLED
EL296UHV FURNACE
icomfort ENABLED
EL296UHV FURNACE
Icomfort Wi-Fi
®
THERMOSTAT
CONVENTIONAL NON-
COMMUNICATING
SYSTEM
COMMUNICATING
SYSTEM
CS 7000
THERMOSTAT
*24V IN jumper not used in non-
communicating configuration
24V HUMIDIFIER CONNECTIONS
120V CONNECTIONS
HEPA BYPASS FILTER X2680 HEPA INTERLOCK KIT
PASS INDOOR BLOWER MO
TOR COMMON WIRE
THROUGH CURRENT LOOP.
SEE HEPA INTERLOCK KIT
FOR INSTALLATION DETAILS
LVCS VENTILATION CONTROL SYSTEM
SEE LVCS VENTILATION
INSTRUCTIONS FOR DAMPER &
SENSOR WIRING
icomfort
®
ENABLED
EL296UHV FURNACE
icomfort
®
ENABLED OUTDOOR AIR
CONDITIONING OR HEAT
PUMP UNIT
(POWER COMPANY INTERRUPTION SYSTEMS ARE
WIRED SAME AS OVERFLOW SWITCH)
icomfort
®
ENABLED
EL296UHV FURNACE
CUT R-DS
W914
DS
R
2 STAGE FURNACE
COMMUNICATING
SYSTEM WIRING
NON-COMMUNICATING
SYSTEM WIRING
“HUM” CONTACT IS
CLOSED ANYTIME
HUMIDITY DEMAND
IS PRESENT
icomfort
®
ENABLED
EL296UHV FURNACE