Page 36
F-K1ECON20B / K1ECON22B-1 Economizer,
(Field- or Factory-Installed)
economizer.
Damper minimum position can be set lower than traditional
minimum air requirements resulting in cost savings. The
increases.
TABLE 15
Sensors Dampers will modulate to 55°F dis-
charge air (RT6) when:
Single OA Sensible
cooling setpoint.
Single OA Sensible
setpoint.
MIXED AIR SENSOR (R1) LOCATION
R1 MIXED
AIR SENSOR
FIGURE 19
ECONOMIZER
ACCESSORY
PANEL MULLION
DIVIDER PANEL
(Attach with two
provided screws)
BOTTOM OF
COMPRESSOR
SECTION
FLANGED
RETURN AIR
OPENING
ECONOMIZER
FIGURE 20
To Next Page
Loading...