Lennox LPH060-160P434 - Page 22

20
NOTE
( ) Cooling capacities are rated at 95℉ amblent,80℉ entering dry bulb,67℉ entering wetⅠ
bulb.Units are suitableforoperationto±2 0%ofnominal CFM.
( )Heating capacities are based on the following conditions:Indoor temperature ℉Ⅱ 68
entering dry bulb, ℉ entering dry bulb,outdoor temperature 4 ℉ entering dry bulb,43℉59 5
entering dry bulb.
5Tons
Heat Pump
Power voltage/phase/frequency 230V/1/60
Cooling(Btu/h) 55000
Heating(Btu/h) 56000
EER/COP(Btu/h W) 10.0
SEER(Btu/W) 16.0
Length(mm) 1486
Width(mm） 1086
Height（mm) 840
200
204
1490*1070*865
R410A
electronic expansion valve
Compressor Quantity/Type 1/Rotor compressor
Rows 2
Fins per inch 17
Tube diameter(in.) φ7
Rows 4
Fins per inch 17
Tube diameter(mm) φ7
Quantity used/diameter(mm) 1/600
Type Propeller
Drive type direct
Quantity speeds 2
Quantity motors/power(kW) 1/0.23
Motor RPM 1100
Total nominal CFM 4000
Quantity used/diameter(in.) 1/10*10
Type FC centrifugal
Drive type direct
Quantity speeds 2
Quantity motors/power(kW) 1/0.35
Motor RPM 765
Total nominal CFM 1650
Outdoor Static Pressure（Pa） standard（Minimum-Maximum） 0
Indoor Static Pressure（Pa） standard（Minimum-Maximum） 50
Cooling Operation Range °F 63-118
Heating Operation Range °F 19-90
Nominal ton
Model type
Capacity
Performance
Dimensions
Net weigt（Kg）
Outdoor fan
Indoor fan
Gross weight（Kg）
Packing dimension: LxWxH
Refrigerant type
Flow control
Outdoor coil
Indoor coil
Tab.7-6
Physical Data( )For Inverter Units