CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a with one of these
parts, contact a service technician.
To install a hot-swap power supply, complete the following steps:
Step 1. Before you begin, read “Safety” on page v and “Installation guidelines” on page 44.
Step 2. Touch the static-protective package that contains the power supply to any unpainted metal surface
on the server; then, remove the power supply from the package and place it on a static-protective
surface.
Step 3. If you are installing the power supply into an empty bay, remove the power-supply filler panel from
the power-supply bay.
Step 4. Use one of the following procedures to install the power supply.
a. To install a 1400-watt power supply, complete the following steps:
1. Grasp the handle on the rear of the power supply and slide the power supply forward into
the power-supply bay until it clicks. Make sure that the power supply connects firmly into
the power-supply connector.
Filler
panel
1400-watt ac
power supply
Power supply
release tab
2. Go to Step 5 step 4 on page 110.
b. To install a 900-watt power supply, complete the following steps:
1. Insert the power-supply spacer into the left side (against the bay wall) of the power-supply
bay and slide it in until it snaps into place on tabs on the side of the bay.
Chapter 2. Installing optional devices 109
To Next Page
Loading...
