Step 6. Connect the power cable to the power connector on the drive backplane.
Note: To ensure that the hard disk drive ID numbering matches the drive ID numbering on the front
of the server, make sure that you connect the shorter blue power cable connector to the bottom
backplane and connect the grey power cable connector to the top backplane.
Step 7. Connect the SAS/SATA signal cable to the backplane and to the adapter.
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation” on
page 117.
114
System x3850 X6 and x3950 X6 Installation and Service Guide
To Next Page
Loading...
