Step 3. From the Setup utility main menu, select Boot Manager.
Step 4. Select Add Boot Option; then, select Generic Boot Option and Embedded Hypervisor. Press
Enter, and then press Esc.
Step 5. Select Change Boot Order and then select Change the order. Use the Up arrow and Down Arrow
keys to select Embedded Hypervisor and use the plus (+) and minus (-) keys to move Embedded
Hypervisor in the boot order. When Embedded Hypervisor is in the correct location in the boot
order, press Enter. Select Commit Changes and press Enter.
Step 6. Select Save Settings and then select Exit Setup.
If the embedded hypervisor flash device image becomes corrupted, you can download the image from
http://
www3.lenovo.com/us/en/data-center/software/c/software
.
For additional information and instructions, see the VMware vSphere Installation and Setup Guide at the
vSphere Installation and Setup Guide.
Configuring the Ethernet controller
This topic provides information about configuring the Ethernet controllers.
The Ethernet controller provides an interface for connecting to a 1 Gbps or 10 Gbps network and provides
full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the network.
If the Ethernet ports support auto-negotiation, the controller detects the data-transfer rate (100BASE-T,
1000BASE-T, or 10GBASE-T) and duplex mode (full-duplex or half-duplex) of the network and automatically
operate at that rate and mode.
You do not have to set any jumpers or configure the controller. However, you must install a device driver to
enable the operating system to address the controller. For device drivers and information about configuring
the Ethernet controller, go to
http://datacentersupport.lenovo.com/.
Enabling Features on Demand Ethernet software
This topic provides information about enabling Features on Demand Ethernet software.
You can activate the Features on Demand (FoD) software upgrade key for Fibre Channel over Ethernet
(FCoE) and iSCSI storage protocols that is integrated in the integrated management module. For more
information and instructions for activating the Features on Demand Ethernet software key, see the Features
on Demand User’s Guide at
https://fod.lenovo.com/lkms/angular/app/pages/index.htm#/help. To download the
document and or more information about Features on Demand, go to
https://fod.lenovo.com/lkms, log in, and
click Help.
Enabling Features on Demand RAID software
This topic provides information about enabling Features on Demand RAID software.
Integrated into the integrated management module is a Features on Demand RAID software upgrade key that
you can activate to get support for RAID levels 5 and 50 or 6 and 60 (depending on the Features on Demand
key). For more information and instructions for activating the Feature On Demand RAID software key, see the
Features on Demand User’s Guide at
https://fod.lenovo.com/lkms/angular/app/pages/index.htm#/help. To
download the document or to find more information about Features on Demand, go to
https://fod.lenovo.com/
lkms
, log in, and click Help.
Chapter 3. Configuration information and instructions 139
To Next Page
Loading...
