Attention: Remove only one cover (on one side) at a time to protect the compute book
components on the other side of the compute book from being damaged.
Compute book
cover
Cover release/
touch points
Microprocessor
heatsink
Compute book
Step 6. Lift the cover off and set it aside.
Replacing the compute book cover
This information provides instructions on how to replace the compute book covers.
The compute book has a cover on the left side and a cover on the right side for access to the microprocessor
and DIMMs. Use the same procedure to remove both covers.
To access the microprocessor and DIMMs 1 through 12, remove the left cover.
To access DIMMs 13 through 24, remove the right cover.
To replace the compute book covers, complete the following steps:
Step 1. Align the cover on the rear of the compute book and slide it toward the front of the compute book
until it is secure.
Chapter 6. Removing and replacing components 223
To Next Page
Loading...
