Drive tray
assembly
Drive handle
(in open position)
Activity LED
Status LED
b. Rotate the handle outward.
c. Grasp the handle and pull the drive out of the drive bay.
d. Skip to step 5.
Step 3. Removing a 1.8-inch hot-swap drive:
a. Remove the filler panel.
b. Grasp the orange and black release latch on the drive tray handle for the drive that you want to
remove and slide the release latch down to unlock the drive-tray handle; then, rotate the drive
tray handle to the right and the pull the handle toward you to slide the drive out of the bay. Lift
the drive out of the drive tray.
Chapter 6. Removing and replacing components 239
To Next Page
Loading...
