3. Reconnect the cables to the drive backplane that you removed earlier.
4. Reinstall the drives that you removed from the old assembly into the new drive backplane assembly, if
you have not done so (see “Replacing 2.5-inch and 1.8-inch hot-swap drives” on page 240).
5. Reinstall the filler panels.
6. Reinstall the storage book into the server.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the server.
244
System x3850 X6 and x3950 X6 Installation and Service Guide
To Next Page
Loading...
