Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a with one of these
parts, contact a service technician.
To install a hot-swap power supply, complete the following steps:
1. Before you begin, read “Safety” on page v and “Installation guidelines” on page 44.
2. Touch the static-protective package that contains the hot-swap power supply to any unpainted metal
surface on the server; then, remove the power supply from the package and place it on a static-
protective surface.
3. If you are installing a hot-swap power supply into an empty bay, remove the power-supply filler panel
from the power-supply bay.
4. Replacing a 1400-watt hot-swap power supply.
a. Grasp the handle on the rear of the power supply and slide the power supply forward into the power-
supply bay until it clicks into place
Filler
panel
1400-watt ac
power supply
Power supply
release tab
Make sure that the power supply connects firmly into the power-supply connector
.
b. Go to step 66 on page 259.
258
System x3850 X6 and x3950 X6 Installation and Service Guide
To Next Page
Loading...
