Installation tool
Screws
Microprocessor
f. Twist the handle on the microprocessor tool counterclockwise to the open position (as shown in the
illustration) to insert the microprocessor into the socket. The microprocessor rests flush on the
socket only if it is properly installed.
Notes:
• Do not press the microprocessor into the socket.
• Do not touch the thermal grease on the bottom of the heat sink or on top of the microprocessor.
Touching the thermal grease will contaminate it.
• Make sure that the microprocessor is oriented and aligned correctly in the socket before you close
the microprocessor bracket frame.
g. Lift the microprocessor installation tool from the socket.
h. Remove the microprocessor dust cover.
Chapter 6. Removing and replacing components 289
To Next Page
Loading...
