Filler
panel
Spacer
750-watt ac
power supply
Power supply
release tab
Spacer
release tab
5. Slide the power supply spacer into the bay until it snaps into place on the tabs that are on the side of the
bay.
6. Grasp the handle on the rear of the power supply and slide the power supply forward into the power-
supply bay until it clicks. Make sure that the power supply connects firmly into the power-supply
connector.
7. Route the power cord through the hook-and-loop strap so that it does not accidentally become
disconnected.
8. Turn on the circuit breaker(s) for the dc power supplies.
9. Reconnect any external cables that you disconnected.
10. Turn on the server and the peripheral devices.
11. Make sure that the server starts correctly and recognizes the newly installed device, and make sure that
no error LEDs are lit.
Chapter 6. Removing and replacing components 301
To Next Page
Loading...
