Replacing the shuttle
Use this information for instructions on how to replace the chassis shuttle.
To replace the chassis shuttle, complete the following steps:
Note: This procedure is for both the 4U (4-socket) and 8U (8-socket) server configurations.
Step 1. Reinstall the midplane. Align the slots on the sides of the midplane with the alignment pins on the
shuttle and lower the midplane onto the pins until the midplane is seated in place on the shuttle.
Midplane
assembly
Alignment pins
Alignment pins
Shuttle
Step 2. Make sure that the cam handles are open. Grasp the shuttle with your hand through the hole on the
center of the shuttle and grasp the bottom of the shuttle with your other hand and align it with the
shuttle slot; then, slide the shuttle into the chassis until it is seated firmly.
The following is an illustration of the 4U shuttle:
The following is an illustration of the 8U shuttle:
Chapter 6. Removing and replacing components 309
To Next Page
Loading...
