Drive tray
assembly
Filler panel
Drive handle
(in open position)
d. Gently push the drive assembly into the drive bay until the drive stops.
e. Rotate the drive-tray handle to the closed (locked) position.
f. Skip to step 6.
Step 5. To install a 1.8-inch drive, complete the following step:
a. Remove the filler panel (EMC filler panel).
b. Grasp the black and orange release latch on the drive tray handle of the drive tray in which you
want to install the drive and slide the release latch to the right to unlock the drive tray handle;
then, rotate the drive tray handle to the right.
Chapter 2. Installing optional devices 77
To Next Page
Loading...
