To install the full-length I/O book, complete the following steps:
Step 1. Before you begin, read “Safety” on page v and “Installation guidelines” on page 44.
Step 2. Remove the filler panel from the I/O bay.
Step 3. Touch the static-protective package that contains the new I/O book to any unpainted surface on
the outside of the server; then, remove the I/O book from the package.
Step 4. Remove the I/O book cover. Slide the cover toward the front of the server and lift it off of the I/O
book.
Step 5. Install your adapter (see “Installing an adapter in the full-length I/O book” on page 91).
Step 6. Install the extension bracket that comes with the I/O book. Insert the bracket into the slots in the I/
O bay (as shown in the illustration).
Release latch
Extension
bracket
Filler
panel
Handle
Step 7. Open the I/O book cam handle.
Step 8. Align the I/O book with the I/O bay in the server and slide it into the server.
Step 9. Rotate the handle all the way up and push it into the server until it locks in place.
If you have other devices to install or remove, do so now. Otherwise, go to “Completing the installation” on
page 117.
Installing an adapter
User this information for an overview of the type of adapters that the server supports and information about
installation rules.
The following notes describe the types of adapters that the server supports and other information that you
must consider when you install an adapter.
Chapter 2. Installing optional devices 83
To Next Page
Loading...
