Table 23. RRcmd parameters (continued)
Command Result
List List files that are included in the backup level (must include
location and level).
Basebackup Initiate an alternative base backup. This is not to be used as a
basis for incremental backups, and must include the location,
name and level. The level must be less than 99. If another base
backup with the same level already exists, it will be overwritten.
Sysprepbackup Stage a backup operation in the Pre Desktop Area after the
computer is rebooted. The primary use for this feature is to
capture a Sysprep backup.
Notes:
1. In some cases, the progress bar does not move. If this occurs,
you can verify the backup is occurring by listening to the hard
disk drive. When the backup is complete, you will receive a
message that the backup is complete.
2. Sysprepbackup in Windows 7 is not allowed to be copied after
it is made; otherwise, it will cause problems when restoring the
backup because the related REGISTRY values have not been
set. It is recommended to create the Sysprepbackup directly to
the external media location.
Copy Copy backups from one location to another. This command is also
known as archive and must include the location.
Rejuvenate Rejuvenate operating system to the specified backup.
Delete Delete backups. This command must include the location.
Changebase Change files in all backups based on file.txt contents. Options in
file.txt are:
A Add
D Delete
R Replace
Filter=filterfile Files and folders that will be restored. This command is used only
with the Restore command.
Location=c One or more of the following can be selected with the associated
result:
L For primary local hard drive
U For USB hard drive
S For second local hard drive
N For network
C For CD/DVD Restore
name=abc Where abc, is the name of the backup.
62 Rescue and Recovery 4.3 Deployment Guide
To Next Page
Loading...
Need help?
General