Information only; no action is required
• FQXSPPP4005I: The power cap value changed from [arg1] watts to [arg2] watts by user [arg3].
Power Cap values changed by user
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0113
User Action:
Information only; no action is required
• FQXSPPP4006I: The minimum power cap value changed from [arg1] watts to [arg2] watts.
Minimum Power Cap value changed
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0114
User Action:
Information only; no action is required
• FQXSPPP4007I: The maximum power cap value changed from [arg1] watts to [arg2] watts.
Maximum Power Cap value changed
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0115
User Action:
Information only; no action is required
• FQXSPPP4008I: The soft minimum power cap value changed from [arg1] watts to [arg2] watts.
Soft Minimum Power Cap value changed
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0116
User Action:
Information only; no action is required
• FQXSPPP4009I: The measured power value exceeded the power cap value.
Chapter 3. XClarity Controller events 99
To Next Page
