Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0014
User Action:
Information only; no action is required
• FQXSPSE4002I: Security: Userid: [arg1] using [arg2] had [arg3] login failures from WEB client at IP
address [arg4].
This message is for the use case where a user has failed to log in to a Management Controller from a web
browser.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0016
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the correct login ID and password are being used.
2. Have the system administrator reset the login ID or password.
• FQXSPSE4003I: Security: Login ID: [arg1] had [arg2] login failures from CLI at [arg3].
This message is for the use case where a user has failed to log in to a Management Controller from the
Legacy CLI.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0017
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the correct login ID and password are being used.
2. Have the system administrator reset the login ID or password.
• FQXSPSE4004I: Remote access attempt failed. Invalid userid or password received. Userid is
[arg1] from WEB browser at IP address [arg2].
This message is for the use case where a remote user has failed to establish a remote control session
from a Web browser session.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Remote Login
SNMP Trap ID: 30
CIM Prefix: IMM CIM ID: 0018
Chapter 3. XClarity Controller events 123
To Next Page
