Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPPW0047M Numeric sensor [NumericSensorElementName] going high (upper
critical) has asserted.
Error
FQXSPPW0061M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPPW0063M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPSD0001L The [StorageVolumeElementName] has a fault.
Error
FQXSPSD0005L Array [ComputerSystemElementName] is in critical condition. Error
FQXSPSD0006L Array [ComputerSystemElementName] has failed. Error
FQXSPSE4000I Certificate Authority [arg1] has detected a [arg2] Certificate Error. Error
FQXSPUN0019M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPUN0020N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPUN0023N Sensor [SensorElementName] has transitioned to non-recoverable.
Error
FQXSPUN0047N Sensor [SensorElementName] has transitioned to non-recoverable.
Error
FQXSPUP0007L Invalid or Unsupported firmware or software was detected on system
[ComputerSystemElementName].
Error
FQXSPUP4000I Please ensure that the Management Controller [arg1] is flashed with
the correct firmware. The Management Controller is unable to match
its firmware to the server.
Error
FQXSPUP4003I [arg1] firmware mismatch internal to system [arg2]. Please attempt to
flash the [arg3] firmware.
Error
FQXSPUP4004I XCC firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the XCC firmware to the same level on all
nodes/servers.
Error
FQXSPUP4005I FPGA firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the FPGA firmware to the same level on all
nodes/servers.
Error
List of XClarity Controller events
This section lists all messages that can be sent from the XClarity Controller.
• FQXSPBR4000I: Management Controller [arg1]: Configuration restored from a file by user [arg2].
This message is for the use case where a user restores a Management Controller configuration from a file.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0027
User Action:
54
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute Node
Messages and Codes Reference
To Next Page
Loading...
