Lenovo ThinkSystem D2 - Page 61

1. Turn off the server and disconnect it from the power source. You must disconnect the server from AC
power cycle to reset the XCC.
2. After 45 seconds, reconnect the server to the power source and turn on the server.
3. Retry the operation.
• FQXSPBR4008I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]
failed to start.
This message is for the use case where a user restores a Management Controller configuration from a file
and the restoration fails to start.
Severity: Error
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0138
User Action:
Complete the following steps until the problem is solved:
1. Turn off the server and disconnect it from the power source. You must disconnect the server from AC
power cycle to reset the XCC.
2. After 45 seconds, reconnect the server to the power source and turn on the server.
3. Retry the operation.
• FQXSPBR400FI: The neighbor group management is [arg1] by user [arg2] from [arg3] at IP address
[arg4].
Neighbor group management is enabled or disabled by user
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0272
User Action:
Information only; no action is required
• FQXSPBT0007I: No bootable media available for system [ComputerSystemElementName].
This message is for the use case when an implementation has detected a System with No Bootable
Media.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0286
User Action:
Please ensure bootable media be installed correctly.
• FQXSPCA0002M: Numeric sensor [NumericSensorElementName] going low (lower critical) has
asserted.
Chapter 3. XClarity Controller events 57