1. Make sure that all I/O expansion adapters have correct and matching levels of device drivers and
firmware.
2. Check the event log of system management module(SMM) or xClarity Controller for additional
information about failing components.
3. If there are no entries related to the error in the event log, contact service.
• FQXSPIO2003I: System [ComputerSystemElementName] has recovered from a diagnostic
interrupt.
This message is for the use case when an implementation has detected a recovery from a Front Panel NMI
/ Diagnostic Interrupt
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0223
User Action:
Information only; no action is required
• FQXSPIO2004I: Bus [SensorElementName] has recovered from a bus timeout.
This message is for the use case when an implemenation has detected that a system has recovered from
a Bus Timeout.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0225
User Action:
Information only; no action is required
• FQXSPIO2006I: System [ComputerSystemElementName] has recovered from an NMI.
This message is for the use case when an implementation has detected a Software NMI has been
Recovered from.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0230
User Action:
Information only; no action is required
• FQXSPIO4001I: GPU Board Status was changed by [arg1] of [arg1].
This message is for the use case where GPU Board Status was changed.
Severity: Info
Serviceable: No
Chapter 3. XClarity Controller events 77
To Next Page
