1 : ADMIN SETTINGS
a. Press [*] [#] key, voice prompt "factory status, please add 6-12 digit administrator password press
[#] key to confirm", the user enters the password, press [#] key to confirm.
b. Enter the password again when prompted, press the [#] key to confirm, and then enter the same
set of passwords.
c. Voice prompt “Registration successful”, the system automatically jumps to the main menu, the
user exits according to the voice navigation or performs other operations.
a. If this product fails to verify the key 5 times during use, the system will lock it for 90 seconds, and
enter the correct key again after 90 seconds to use it normally.
b. Please pay attention to the battery level reminder before going out, and replace the battery in
time when the power is insufficient.
c. The spare emergency key must be placed outdoors, and do not leave all of it at home (can be
placed in a private car, parents' or children's home).
1.1 : ADD ADMINISTRATOR PASSWORD
1.2 : ENTER THE MAIN MENU
Press the [*] [#] key, please use the administrator password for verification. After entering the main
menu, the user can press the corresponding number key to select the operation according to the
menu number.
1. Password Management
2. Fingerprint Management
3. Card Management
4. Face Management
5. Wireless Pairing
6. System Setting
1. Add Fingerprint
2. Delete Fingerprint
3. Delete All Fingerprint
1. Network Setting
2. Set or Query the Time
3. Volume Setting
4. Combine Mode
5. Firmware Version
6. Operation Record Query
1. Smart Config
2. AP Config
1. High Volume
2. Medium Volume
3. Low Volume
4. Silent Mode
1
1
1. Time Setting
2. Time Query
2
1. Active
2. De-activate
4
3
2
1. Add Card
2. Delete Card
3. Delete All Card
3
1. Add Face
2. Delete Face
3. Delete All Face
4. PIR Setting
4
6
1. Wireless Pairing
2. Activate
3. De-activate
5
1. Modify The Admin Password
2. Add User Password
3. Delete User Password
4. Delete All User Password
To Next Page
Loading...