Lenoxx CD419BJ - Important Safety Instructions

T
TROUBLESHOOTING GUIDE
THE OPERATING INSTRUCTIONS REFLECT THE CURRENT TECHNICAL SPECIFICATION OF THIS
PRODUCT AT TIME OF PRINT.
WE RESERVE THE RIGHT TO CHANGE SPECIFICATIONS FOR TECHNICAL REASONS WITHOUT PRIOR
NOTICE.
14
IMPORTANT SAFETY INSTRUCTION
Please read this owner’s guide
Please take the time to follow the instructions in this owner’s guide carefully. It
will help you set up and operate your system properly and enjoy all of its
advanced features. Please save this owner’s guide for future reference.
WARNING:
To reduce the risk of fire or electrical shock, do not expose the product to rain
or moisture. Liquids can cause a failure and/or a fire hazard. DO NOT
OPEN THE BACK PANEL FOR RISK OF ELECTRICAL SHOCK
This symbol indicates that there are important operating instructions in
the literature accompanying this unit. This symbol indicates that
dangerous voltage constituting a risk of electric shock is present within
this unit. To reduce the risk of fire or electrical shock, do not expose this product to
rain or moisture.
This product is intended to be used only with the power supply provided.
This product must be used indoors. It is NOT designed for outdoors use.
WARNING:
Keep the remote control battery away from children. It may cause a fire
or chemical burn if mishandled. Dispose of used batteries promptly.
Please dispose of used batteries properly, following any local regulations.
1
The following checks will assist in the correction of most problems which you
may encounter with your set. Before going through the check list below, first
check the following points.
The power cord must be connected firmly.
Should any problem persist after you have made these checks consult
your nearest dealer
Symptom
Possible Causes (and Remedies)
R
ADIO RECEPTION
No radio
reception
The MODE selector has not been set to the correct position.
Adjust the VOLUME knob.
Rotate the TUNING knob to find a radio station.
Switch the AUX IN jack to “OFF”
CD PLAYER OPERATION
Disc does not play
O
r sound skips
Reload the disc with the label side up
Clean the disc.
Sound skips
Change the installation location.
Unit is not working.
The AC power cord is not connected to an AC wall outlet.
Check that the power cord is connected firmly.
Push the power button from the “OFF” position to the
“ON” position.
GENERAL
Programmed disc play
will not function
Press the STOP button and then program the tracks.
No sound output.
Turn VOLUME knob clockwise.
Switc
h the AUX IN jack to “OFF”.
Check
the position of the line out
switch and the speaker
switch – see page 12 for more info.
Severe hum or noise.
The TV or VCR is too close to the stereo system.
Separate from the TV or VCR.