Radio:
To increase radio reception, use the wire antenna.
Ensure the wire antenna is un-wound, hold it upwards and tape it to a wall.
1. Press the “ON/OFF” button to turn the clock radio on or off.
2. Press the “AM/FM” button to select radio band.
3. Press the “TU+” or “TU-“ button to tune to the desired station.
4. Press the “VOL +” or “VOL -“ button to adjust the volume.
Setting Preset memory stations:
1. Press and hold the “Pre/M+/TIME Set” button for 2 seconds to save the current station to preset memory.
The position number will blink on the screen. While it blinks on the screen within 2 seconds press the
“Pre/M+/TIME Set” button once to save that station to the preset memories.
If the display shows “P01”, the station is saved as Preset 1. If the display shows “P02”, th e station i s save d as Preset
2.
2. Press the “TU+” or “TU-“ button to tune to another radio station.
Repeat the instruction above to save another radio station.
Continue saving desired radio stations.
3. If you wish to save a particular radio station as a certain preset number, that can be done.
When the chosen radio station is shown in the screen,
Press and hold the “Pre/M+/TIME Set” button for 2 seconds to save the current station to preset memory.
The position number will blink on the screen.
While it blinks on the screen within 2 seconds press the “TU+” or “TU-“ button to change the position number to a
different one. Then press the “Pre/M+/TIME Set” button once to save that station to the preset memories.
SPECIFICATIONS:
Frequency Range：AM 540-1600KHz
FM 88 –108 MHz
Power Source: AC 230V ~ 50 Hz, 3W
CR2032 Battery for back up only
Power Output: 400 mW
To Previous Page
Loading...