12
PRECAUTIONS
1. Only use an outdoor extension cord having a 3-prong plug and receptacle that accepts the Lentek
Elite Mosquito Trap’s plug. The Lentek Elite Mosquito Trap has a 3-conductor cord and a
3-prong grounding type plug to fit a properly grounded outlet. Replace damaged cords.
2. The electrical rating of the extension cord must be greater than or equal to the electrical rating of
the Lentek Elite Mosquito Trap (120 Volt / 0.6 Amp). Use an extension cord with 16 gauge or thicker
wire and that has a label stating it is suitable for outdoor use.
3. Do not abuse any electrical cord. Never yank it to disconnect from the receptacle. Keep all cords
away from heat, flammable substances and sharp objects.
4. Devices for retaining the extension cord connection to the power supply cord are available where ever
fine extension cords are sold.
5. The connection between the Lentek Elite Mosquito Trap and the extension cord must always remain
dry and kept off of the ground.
6. Disconnect the Lentek Elite Mosquito Trap from the power supply when not in use, changing
propane tanks, before servicing, cleaning, etc.
7. Do not insert foreign objects into this product.
8. The Lentek Elite Mosquito Trap is for Outdoor Use Only.
9. To avoid electric shock, DO NOT clean the Lentek Elite Mosquito Trap by spraying water or by
immersion in water.
10. All repairs to the Lentek Elite Mosquito Trap must be performed only by qualified service
personnel.
11. Read and follow all instructions affixed to the propane tank.
12. Young children should be carefully supervised when they are in the area of the Lentek Elite Mosquito
Trap.
13. Clothing or other flammable materials should not be hung from the Lentek Elite Mosquito Trap or
placed on or near the Lentek Elite Mosquito Trap.
14. Any guard or other protective device removed for servicing the Lentek Elite Mosquito Trap must be
replaced prior to operating.
15. It is imperative that the compartment, burner and circulating air passage ways of the Lentek Elite
Mosquito Trap be kept clean at all times.
16. A maximum of a 9 kg (20 lb.) LP-Gas cylinder shall be used with the Lentek Elite Mosquito Trap.
17. The LP-Gas cylinder must be provided with a shutoff valve terminating in an LP-Gas supply cylinder
valve outlet specified for Connection No. 791 in the Standard for Compressed Gas Cylinder Valve
Outlet and Inlet Connections, ANSI/CGA-V-1-latest edition (Any standard 9 kg (20 lb.) Propane tank
manufactured after 1999).
18. The LP-Gas cylinder supply system must be arranged for vapor withdrawal and the cylinder must
include a collar to protect the cylinder valve.
19. The LP-Gas cylinder used shall be constructed and marked in accordance with the specifications for
LP-Gas cylinders of the U.S. Department of Transportation (DOT).
20. The Lentek Elite Mosquito Trap shall be used outdoors and only in a well ventilated space and shall
not be used in a building, garage or any other enclosed area.
21. The Lentek Elite Mosquito Trap should be stored indoors when not in use and kept away from
children.
22. The LP-Gas cylinder must be disconnected and removed from the Lentek Elite Mosquito Trap, if the
appliance is stored indoors.
23. LP-Gas cylinders must be stored outdoors in a well ventilated area out of the reach of children.
Disconnected cylinders must have a plastic cap installed and must not be stored in a building, garage
or any other enclosed area.
24. The pressure regulator and hose assembly supplied with the Lentek Elite Mosquito Trap must be used
for connection to the LP-Gas cylinder. Replacement pressure regulators and hose assemblies must be
purchased from Koolatron Inc.
To Next Page
Loading...