10 Update LZ100 / LZV100 and LH100 to Version 3.6
Functions F0 to F20 are transmitted
cyclically.
Functions F0 to F28 are transmitted
cyclically.
Functions F0 to F4 are transmitted
cyclically.
13 8
Press 'Enter' to confirm your
selection.
2.7 Displaying and changing the speed-step mode
To display or change the speed-step mode, proceed as follows:
13 8
Select the address of the locomotive
whose speed-step mode you want to
display or change. Make sure that the
locomotive is set to speed step 0 (if
not, press the hexagonal key).
The menu that was selected
last is displayed.
Press '+' to display the speed-step
mode currently set.
Press '+' again to display the speed
steps available:
To Next Page
Loading...
Need help?
General
