Lenze ECSEE012 - Page 135

Appendix
Code list
11

135
EDBCSXE040 EN 6.0
Parameter
C0022
Designation
Max. charging current after power supply enable
Data type: INTEGER_32
Index: 24553
dec
= 5FE9
hex
Setting of the maximum charging current after power supply enable
Setting range (min. value | unit | max. value) Lenze setting
2.0 A 25.0
ECSxE040: 32.0
(from firmware V4.0)
16.0 A
Parameter
C0023
Designation
Peak current (peak)
Data type: INTEGER_32
Index: 24552
dec
= 5FE8
hex
Display of the peak current (peak)
Note: Can be reset by writing to C0022 (max. charging current after power supply enable).
Display range (min. value | unit | max. value) Information
0.0 A 500.0
Parameter
C0024
Designation
Service code
Data type: INTEGER_32
Index: 24551
dec
= 5FE7
hex
Note: Only the Lenze service is allowed to make changes!
Setting range (min. value | unit | max. value) Lenze setting
23 ms 10000 50ms
Parameter
C0028
Designation
Service code
Data type: INTEGER_32
Index: 24547
dec
= 5FE3
hex
Note: Only the Lenze service is allowed to make changes!
Setting range (min. value | unit | max. value) Lenze setting
16 1216 112
Parameter
C0029
Designation
Service code
Data type: INTEGER_32
Index: 24546
dec
= 5FE2
hex
Note: Only the Lenze service is allowed to make changes!
Setting range (min. value | unit | max. value) Lenze setting
1 70 28
Parameter
C0031
Designation
Service code
Data type: INTEGER_32
Index: 24544
dec
= 5FE0
hex
Note: Only the Lenze service is allowed to make changes!
Setting range (min. value | unit | max. value) Lenze setting
40 100 50
Parameter
C0040
Designation
Power supply enable − power supply module
Data type: INTEGER_32
Index: 24535
dec
= 5FD7
hex
Setting for inhibit or enable of the power supply module
Selection list (Lenze setting printed in bold) Information
0 Inhibit power supply module
1 Enable power supply module