Lenze EVS9326EP - Page 331

Appendix
5.2 Index
5−7
l
EDSVS9332P−EXT DE 2.0
J
JOG setpoint, 2−6
JOG setpoints, 3−227
L
Limiting element (LIM), 3−207
Logic NOT, 3−223
M
Machine parameters, 3−26
Main setpoint, 2−6
Main setpoint path, 3−226
Manual operation, 3−67
Master frequency input (DFIN), 3−164
Measuring systems, 3−34
Measuring systems and zero shifts, 3−35
Monitor outputs of monitoring system (MONIT),
3−218
Motor phase failure detection (MLP), 3−217
Motor potentiometer (MPOT), 3−220
Multi−axis synchronisation (SYNC)
− Configuration examples, 3−267
− Correcting the angle controller, 3−266
− Cycle times, 3−263
− Fault indications, 3−266
− Operating mode, 3−260
− Phase displacement, 3−265
− Scaling, 3−267
− synchronising, 3−261
− Time slot, 3−265
Multi−axis synchronisation (SYNC1), 3−260
N
Nameplate, 1−5
Notes, definition, 1−6
O
Operation inhibit (DISABLE), 3−161
OR operation (OR), 3−230
Oscilloscope function (OSZ), 3−233
Override, 3−62
P
Phase conversion (CONVPHPH2), 3−155
Phase integrator (PHINT), 3−241
− constant input value, 3−242
− Scaling of PHINTx−OUT, 3−243
POS−REF−OK, 3−48
Position encoder at material path, 3−28
Positioning control, 3−19
Positioning mode, Relative positioning, 3−30
Process controller (PCTRL1)
− Control characteristic, 3−238
− Dancer position, tension, pressure controller, 3−237
− Ramp function generator, 3−239
Processing table, 3−12
− Frequent faults, 3−13
Q
QSP (quick stop), 2−10 , 3−215
Quick stop (QSP), 2−10 , 3−161
Quick stop QSP, 3−215
R
Ramp function generator, 3−239
Ramp generator(RFG), 3−246
Resetting a fault, 2−10
S
S ramp, PT1 element, 3−229
S−shaped ramp function generator characteristic,
2−7
Safety instructions
− Definition, 1−6
− Structure, 1−6
Sample and hold function (S&H), 3−248
Selection of direction of rotation, 2−8
Setpoint inversion, Ramp function generator, main
setpoint, 3−228
Setting the integral component, 3−212
Signal conversion (CONV), 3−144
Signal scaling, Formulae, 3−23