L 1.0 EN - 03/2008 9
Global Drive Control | Industrial PC as Gateway
IPC as gateway
Connect to drive
Nur für internen Gebrauch!
r The parameters of the connected drive are read from the connected drive.
4.2.1 Remedy in case of error
r If no drive can be found, the »GDC« displays an error message:
r Proceed as follows to remove the error:
– Check the physical connections to the controller and IPC,
– Make sure that the communication parameters set for the physical configuration
are correct.
F
Information on the respective target system of the »GDC« can be found in the corresponding hardware
manual.
To Next Page
Loading...
