Lenze M850 Series - Page 23

Workow
S1 operaon S2, S3 and S6 operaon
Check operang condions
Dene required input variables
Determine correcon factor
Operang modes and operang me Operang modes and operang me
Ambient temperature and installaon height Ambient temperature and installaon height
Mounng posion Mounng posion
Mean speed ulizaon
Average speed
Determine gearbox eciency
Determine gearbox on the basis of the acng forces
Determine required gearbox load capacity
Calculate required drive power
Check and select geared motor
Check servo motor based on the motor torque characterisc
Final conguraon
Check operang condions
Check
Approvals
Conformies
Supply voltage
Degree of protecon
Ambient temperature
Surface protecon
4Standards and operang condions ^ 40
4Surface and corrosion protecon ^ 29
Informaon on project planning
Drive dimensioning
23