Lenze M850 Series - Page 60

The values given in the tables refer to the centre sha end force applicaon point and are
minimum values calculated according to the most unfavourable condions (force applicaon
angle, mounng posion, direcon of rotaon). The values were calculated with a load
capacity of c= 1.3 and an input speed of 1400 rpm.
In case of dierent operang condions, considerably higher forces can be
transmied. Please get in touch with your Lenze representave
Max. radial force, gearbox with foot (VBR)
Getriebe
Output speed n
2
[rpm]
1000 630 400 250 160 100 63 40 25 16
Max. radial force F
rad,max
[N]
g500-H45 300 400 600 700 800 900 1100 1400 1500 1500
g500-H100 800 1000 1200 1500 1800 2100 2600 2700 2700 2700
g500-H140 1000 1440 1800 2200 2500 3000 3300 3700 4100 4200
g500-H210 1100 1600 2000 2400 2800 3400 3900 4100 4400 4800
g500-H320 1760 2090 2480 3000 3520 4190 5000 5700 5700 5700
g500-H450 2440 2820 3340 4020 4660 5540 6500 7100 7100 7100
g500-H600 3820 4480 5250 6100 7260 8450 9500 9500 9500 9500
g500-H850 4700 5510 6430 7500 8860 10400 11500 11500 11500 11500
g500-H1500 6300 7440 8790 10300 12200 14500 17000 17000 17000 17000
g500-H3000 7510 8880 10100 12400 14600 17200 20000 20000 20000 20000
Reinforced bearings
Getriebe
Output speed n
2
[rpm]
1000 630 400 250 160 100 63 40 25 16
Max. radial force F
rad,max
[N]
g500-H100 1000 1200 1500 1800 2200 2700 3200 3300 3300 3300
g500-H140 1300 1800 2300 2700 3100 3700 4100 4600 5100 5300
g500-H210 1400 2000 2500 3000 3500 4200 4900 5100 5500 6000
g500-H320 2380 3250 4380 5600 6800 7100 7100 7100 7100 7100
g500-H450 4030 5100 6870 8650 8900 8900 8900 8900 8900 8900
g500-H600 7180 8710 9860 11300 12000 12000 12000 12000 12000 12000
g500-H850 9520 10500 11900 13300 15400 15600 15600 15600 15600 15600
g500-H1500 12600 14600 16500 19100 21000 21000 21000 21000 21000 21000
g500-H3000 16100 18000 20200 23600 25000 25000 25000 25000 25000 25000
Technical data
Radial forces and axial forces
60