Configuration
Windows CE
6
LDCDS−MC−PBx DE/EN 3.0
41
H1_konfig−−−−(DUMMYSEITEVOR)−−−
Windows CE
The following conditions must be met for operating the card:
1. There must be a "Config" folder on the CF card in the storage drive.
2. This folder must contain a firmware file named "Firmware.nxt".
3. The card must be configured:
– MC−PBS (MPI): Configuration via an end application.
– MC−PBM: There must be a "Config.dbm" file in the "Config" folder. Further
information on this can be found in the documentation for your FDT frame
application.
At the next system start, the driver loads the firmware and the configuration from the
"Config" folder to the communication card.
Note!
No special support is provided currently if you use the communication card in
your own applications. For special projects, please contact your sales office.
To Next Page
Loading...
Need help?
General
